Publicidad
Idiomas disponibles
Idiomas disponibles
The Installation
Once you have collected the information or printed out the information
sheet on your particular vehicle from the Axxess website (www.axxessinter-
face.com) you're ready to install the ASWC.
So here we go:
1) Connect the Black wire of the ASWC (pin 6) to ground. You may use the
same grounding point as the aftermarket radio.
2) Connect the Red wire of the ASWC (pin 12) to a 12 volt accessory wire,
one that turns on and off with the ignition key.
3) Locate the correct SWC wire(s) in the vehicles radio or secondary
harness as described in the vehicle information sheet found in the
Axxess website. Connect the correct wire color(s) from the ASWC to the
vehicles steering wheel control wire(s) in the vehicle.
We recommend that the wires are soldered for the best and most secure
connection. T-Taps are not recommended due to the higher chance of an
intermitted connection.
4) If you are using an Eclipse or Kenwood radio, plug the female 3.5mm
connector with the Brown and Brown/White wires into the male 3.5mm
connector of the ASWC harness.
* For Kenwood radios:
Connect the Kenwood SWC wire (normally Blue/Yellow) to the Brown wire
of the ASWC. Isolate and tape the Brown/White wire, it will not be used.
* For Eclipse radios:
Connect the Eclipse SWC wires (Normally Brown and Brown/Black) to the
Brown and Brown/White wires of the ASWC. Brown goes to Brown and
5
Publicidad
