Mounting The Quickfix Bracket - SICK deTec2 Core Instrucciones De Montaje

MOUNTING INSTRUCTIONS
4

Mounting the QuickFix bracket

8 M O U N T I N G I N S T R U C T I O N S | deTec2 Core, deTec4 Core
DANGER
Hazard due to lack of effectiveness of the protective device
Persons and parts of the body to be protected may not be recognized in case of non-
observance.
The end with the cable connection must point in the same direction for the sender
b
and receiver.
Mount the sender and receiver on a level surface.
b
Mount the sender and receiver such that a right-angled protective field is estab‐
b
lished, i.e., when mounted vertically at the same height. For minor adjustments
when aligning, the sender and receiver can be adjusted longitudinally in the brack‐
ets.
If possible, mount the top bracket at a height such that the offset in the housing of
b
the safety light curtain sits on the bracket. This prevents the safety light curtain
from sliding down during mounting.
Tighten the screws used to mount the bracket to a torque of 5 Nm to 6 Nm.
b
Tighten the screws used to secure the safety light curtain in the bracket to a tor‐
que of 2.5 Nm to 3 Nm. Higher torques can damage the bracket while lower tor‐
ques do not provide adequate fixation to prevent the safety light curtain from mov‐
ing.
When mounting, make sure that sender and receiver are aligned correctly. The
b
optical lens systems of sender and receiver must be located opposite one another.
If necessary, use a water level to check the components are parallel.
b
Mounting can be carried out in two ways:
• On the side
With the M5 screw through the QuickFix bracket to the machine or profile
°
frame. A screw nut or threaded hole is required on the machine or profile
frame.
With the M5 screw through the machine or profile frame to the QuickFix
°
bracket. A screw nut is required for each QuickFix bracket.
• On the back
With the M5 screw through the QuickFix bracket to the machine or profile
°
frame. A screw nut or threaded hole is required on the machine or profile
frame.
Mounting: B1
8019319/2016-04-06 | SICK
Subject to change without notice