Mounting The Device; Electrical Installation - SICK CSM Instrucciones De Uso

OPERATING INSTRUCTIONS
4.3

Mounting the device

en
5

Electrical installation

32 O P E R A T I N G I N S T R U C T I O N S | CSM
9
Figure 1: CSM
1. Install the sensor via the fixing hole so that the light spot enters the mark
longitudinally and the test object has the least possible vertical and horizontal
movement. Note the sensing distance while doing so.
2. Compensate for the vertical and horizontal movement of the test object by marks
of suitable lengths.
3. Ensure that any sensor movement does not affect the sensing distance.
To secure a stable detection when having high gloss material a tilt angle of 10°-15°
might be necessary.
Distance x:
1
CSM-xxx1xxxx = 12.5 mm
CSM-xxxBxxxx = 15 mm
Note the sensor's maximum permissible tightening torque of 0.4 Nm.
Make sure that the sensor movement does not influence the sensing distance.
Operation in standard I/O mode:
The sensors must be connected in a voltage-free state. The following information must
be observed, depending on the connection type:
– Male connector connection: Pin assignment
– Cable: Wire color
Only apply voltage and switch on the voltage supply once all electrical connections have
been established.
x
1
8
8027352/2022-05-19 | SICK
Subject to change without notice