Serpento ASPID 150 Manual De Usuario página 73

32
Adjustment of the Throttle Cable Clearance
I. Loose the locking nut 1.
2. Turn the adjusteta so that the cable clearance is kept within a range of 0.5 - 1.0 mm.
3. Tighten the locking nut after adjusting the clearance.
CAUTION
After the adjustment of cable, check the grip to see Kit can be turned normally. i he idle speed should not be Increased due to this adjustment.
The throttle grip should be able to turn freely.
Adjustment of the Clutch
Before the clutch is rcleased, the cable clearance measured from the lever of clutch should be 4 mm. If the clearance fails to meet this
requirement, make an adjustment as the following method.