Instalation; Lifting; Mounting On Engine; Assembly Format Sae - Sincro SK 400 Manuale Di Uso E Manutenzione

ENGLISH

6. INSTALATION

6.1 Lifting

Lift and handle the generator with suitable equipment either
on a pallet or by the lifting lugs located on the generator in
the positions indicated in the fi gure.
When lifting the generator use equipment with a load
bearing capacity of at least 3000kg.
An insuffi cient loadbearing capacity can
cause severe injury and damage.
CAUTION!
The lifting lugs on the generator have been
designed for lifting only the generator and
not the whole electricity generating set.
CAUTION!
When lifting and handling single bearing generators they
must be kept horizontal in order to avoid, if operations should
go wrong, the rotor from slipping out and being damaged
and possibly causing severe injury.

6.2 Mounting on engine

6.2.1 Assembly format SAE

Before assembly, check that the coupling
seats (both on generator and engine) are in
order and perfectly clean.
CAUTION!
22
Before assembly, be sure that the transit
bar that holds rotor in position during
transport, is removed.
CAUTION!
• Remove the transport bar from the generator.
• Remove the protective grid (4) from the bell.
• Make sure the diameter of the disk (3) corresponds with
the diameter of the seat of the fl ywheel (2).
• Fix the generator to the engine by locking the SAE bell
(1), making sure that the holes in disk and fl ywheel are
aligned.
1
3
2
• Check that the disk is in contact with the fl ywheel.
• Lock the disk into the fl ywheel.
• Support the assembly on antivibration plugs making sure
that engine and generator are level.
• Remount the grid block the hooking closures (5) and
insert the cotter pin (6) paying attention to open the anti-
slip legs.
Inadequate protection and/or bad alignment
of the generator can cause injury and/or
!
damage to equipment.
WARNING!