Led Indicator - Taurus HOMELAND LASER Manual Del Usuario

- Press / button to change the date. After
setting, press the (AL) button to confirm and
enter the time setting.
- The hour will begin to flash, press
to adjust time, and press
ween hours and minutes. With each press, the
time increases or decreases 1.
- Press the (AL) button in progress or stop the
robot will beep when the time setting is com-
pleted.
3) CANCEL THE SETTINGS OF THE
CLEANING HOURS
- Press the (AM) button on the remote control
for 4 seconds, the vacuum cleaner will emit a
beep when the cleaning schedule confirmation
is canceled.
4 sec.

LED INDICATOR

LED LIGHT
Flashing blue
/ button
/ to switch bet-
ROBOT STATUS
Charging
Solid blue
Off
Blue light Flash
Fast/Blue and Red
light lash/Flashing
Red/Beep
MAINTENANCE
- Disconnect the battery charger from the mains
and allow it to cool before undertaking any
cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washingup liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- Never submerge the connector in water or any
other liquid or place it under running water.
HOMELAND
CLEANING
LASER
After each
Dust Bin
use
Once every
Filters
week
Once every
Rolling Brush
week
Once every
Side Brushes
month
Once every
Sensors
month
Charging Once every
Pins month
Once every
Swivel wheel
month
Standby / Cleaning / Fully
charged
Robot is off. To conserve
power, the light automati-
cally turns off when robot
is not docked to the char-
ging doc and has been
inactive for 1 minute.
Robot has an error. Refer
to the troubleshooting
section "Anomalies" in this
manual for solutions
REPLACEMENT
FREQUENCY
-
Every 2 months
Every 6-12
months
Every 3-6
months(or when
visibly worn)
-
-
-