Cleaning Modes - Taurus HOMELAND LASER Manual Del Usuario

POWER OFF THE ROBOT
- To turn off the robot press the operation button
(D) next until the operation indicator goes off.

CLEANING MODES

AUTO CLEANING MODE
- The robot starts to vacuum automatically and
combines the different cleaning modes in one
optimizing the cleaning of your home to the
maximum. To use the AUTO cleaning mode,
press the button (AI) on the remote control.
- When the cleaning cycle ends or if the battery
runs out, it returns to the charging base auto-
matically.
SPIRAL CLEANING MODE
- The robot starts vacuum at a particular point
by spiraling outward approximately (1 meter) in
diameter and then spiraling inward to where it
started. To use the spiral cleaning mode, press
the (AO) button on the remote control.
MAX CLEANING MODE
- The robot increases its suction power to provide
a deeper cleaning.
- To use the MAX cleaning mode, press the (AR)
button on the remote control.
- MAX cleaning mode can only be activated
during operation in AUTO cleaning mode.
EDGE CLEANING MODES
- Once the robot finishes cleaning the open
areas of your floor, use the perimeter mode to
make sure it has been cleaned along the walls
and around the legs of the furniture.
- If you prefer a faster cleaning of the edges,
press the button (AP) on the remote control.
GO HOME MODE
- Mode of return to the charging base automati-
cally when the robot detects that only 15% of
the battery is left.
- To activate the Go Home mode, press the (AJ)
button on the remote control.
WATER TANK ICONTROL MODE
- At the end of the suction process, you can
change the dust deposit through the water
tank (AE) to continue cleaning. The water tank
works by dripping so the mop will moisten and