Battery Charge - Taurus HOMELAND LASER Manual Del Usuario

BATTERY CHARGE:

- Warning: A new battery does not come with a
full charge and must be fully charged before
using the device for the first time.
- Charge the battery at room temperature bet-
ween 4 and 40ºC.
- Turn on the ON / OFF button located on the
bottom of the robot.
- Put the robot in the charging base and ensure
that the automatic charging poles are aligned
correctly.
- Operation button (D): the red LED will light
blinking. When the LED stops blinking the robot
is loaded. Load the robot for 4 hours before the
first use.
ACTIVATE THE ROBOT
- Before starting use, ensure that the power
switch (R) is on.
- Press the operation button (D) to awaken the
robot.
- Press the operation button (D) to start cleaning,
you can also start cleaning by pressing the
button (AL) on the remote control.
NOTE: If the battery is about to run out, the robot
will return to the charging base automatically to
recharge.
NOTE: If the load base is inaccessible, the robot
can not be recharged, it will return to the initial
situation and the cleaning system will end. In this
case, place the robot manually in the charging
base so that it can be recharged correctly.
PAUSE THE ROBOT
- To stop the robot press the operation button (D)
or press the on / off button (AL) on the remote
control.
- To resume the cleaning cycle, press the opera-
tion button (D) again.
- For the robot to return to the charging base (U)
press the Go Home button (AJ).