Cleaning Schedule - Taurus HOMELAND LASER Manual Del Usuario

mop the floor.
- Open the hermetic lid of the tank (AG) and
introduce water into the tank.
- Put the mop that is fastened securely.
- Enter the water tank and select the cleaning
mode you need.
IMPORTANT:
- Do not use the mop outdoors.
- Remove the carpets to avoid damaging them.
- Before loading the robot, remove the water tank
and the mop.

CLEANING SCHEDULE

- The robot vacuum cleaner has cleaning sche-
dule settings that allow you to customize when
you clean your home.
- These settings can only be confirmed via the
remote control.
IMPORTANT:
- Make sure that the remote control is close to
the robot while setting the clock or time.
- Make sure that the power switch is in the ON
position.
1) CONFIGURE THE CLOCK OF THE REMOTE
CONTROL
- Press the (AN) button on the remote control,
the time selector starts blinking.
- Press the button
press the (AL) button to confirm, and enter the
setting.
- The hour (Hr) starts to flash, press the
button to set the time, press the
switch between hours and minutes, with each
press, the time increases or decreases 1.
- Press the (AL) button in progress or stop the
robot will beep when the time setting is com-
pleted.
2) CONFIGURE THE CLEANING HOURS
- Press the (AM) button to select and the date
will start flashing. If you don't select a date,
the "SUN" indicator for the day of the week will
start flashing (SUN, MON, TUE, WED, THU,
FRI, SAT).
to select the current day,
/ button to
/