Abicor Binzel MFS-V3 Manual Del Usuario página 10

3 I/O functional description for MFS-V3 outputs
3 I/O functional description for MFS-V3 outputs
Bit Robot inputs / MFS-V3 outputs
0 System ready for operation
1 No fault
2 Process active
3
4 Wire is in window 1
5 Wire is in window 2
Gas pressure present
6
7 Wire available
8 Control lead connected
9 No internal nonconformity
10 Program available
11
Wire movement active
12
13 Arc is on (HW power source)
14 HW power source ready
15
16 Operating-hours-based maintenance due
17 Delivery-time-based maintenance due
18 Cycle-based maintenance due
19
Delivery-amount-based maintenance due
20 In automatic mode
21 Acknowledge operating mode W1
22 Acknowledge operating mode W2
23 Acknowledge operating mode W4
24 Acknowledge
25 Acknowledge
26 Acknowledge
27 Acknowledge
28 Acknowledge
29 Acknowledge
30 Acknowledge
31
Acknowledge
EN - 4
program
W1
program
W2
program
W4
program
W8
program
W16
program
W32
program
W64
program
W128
BUS interface with job selection
Status Description
1 This signal is activated if the 'Release process' signal is
selected by the robot and there is no fault with the MFS wire
feeder
1 This signal is activated if there is no fault with the MFS wire
feeder
1 Response MFS wire feeder with active process
- / -
1 The wire feed is in the specified window 1
1 The wire feed is in the specified window 2
1 Signal is active if gas pressure (M-Box) is present
1 This signal is active if wire is available
1 The control lead for the drives is connected to the MFS system
1 The MFS system's axis controllers do not report
nonconformities.
1 The selected job has a value other than zero for the wire
speed and is therefore classed as available.
1 This signal is activated as soon as the speedometer's
measuring roll moves (time from start signal <100 ms)
- / -
1 Hot wire power source reports that power is flowing
1 Hot wire power source reports that it is ready
- / -
1 The system reports that the specified number of operating
hours until maintenance has been reached
1 The system reports that the specified delivery time until
maintenance has been reached
1 The system reports that the specified number of cycles until
maintenance has been reached
1 The system reports that the specified delivery amount until
maintenance has been reached
1 eBOX is in automatic mode. The process workflow is
determined by the robot. The key-operated switch on the
eBOX is set to automatic
Bin Returns the selected operating mode ***
Bin Returns the selected operating mode ***
Bin Returns the selected operating mode ***
Bin Returns the selected program
Bin Returns the selected program
Bin Returns the selected program
Bin Returns the selected program
Bin Returns the selected program
Bin Returns the selected program
Bin Returns the selected program
Bin Returns the selected program
BEI.0194.0 • 2019-08-06