Abicor Binzel MFS-V3 Manual Del Usuario página 12

4 I/O functional description for MFS-V3 inputs
4 I/O functional description for MFS-V3 inputs
Bit Robot inputs / MFS-V3 outputs
0 Release process
1 Acknowledge fault
2 Start wire forwards
3 Feed in the wire
4 Start wire backwards
5 Hot wire
6 Gas valve
7 Air blast valve
8
9
10
11
12
13
14
15
16 Reset operating-hours-based maintenance
warning
17 Reset delivery-time-based maintenance
warning
18 Reset cycle-based maintenance warning
19 Reset delivery-amount-based maintenance
warning
20
21 Operating mode W1
22 Operating mode W2
23 Operating mode W4
EN - 6
BUS interface with job selection
Status Description
1 The MFS system reports 'System ready for operation'.
If the signal drops out, the process on the MFS is
instantly stopped
1 If a nonconformity occurs, this remains until the robot
control system sends the 'acknowledge fault' signal to
the MFS system
1 The forwards wire feed is started but without the active
triggering of a hot wire power source. The 'Release
process' signal must be activated
1 The wire is fed in
1 The backwards wire feed is started but without the
active triggering of a hot wire power source. The
'Release process' signal must be activated
1 If this signal is activated, the hot wire power source is
triggered when 'Start wire forwards' is selected
1 If the signal is activated, the gas valve (Media box) is
switched on.
1 If the signal is activated, the air blast valve (Media
box) is switched on.
- / -
- / -
- / -
- / -
- / -
- / -
- / -
- / -
1 The counter indicating the number of operating hours is
reset to zero
1 The counter indicating the delivery time is reset to zero
1 The counter indicating the number of cycles is reset to
zero
1 The counter indicating the delivery amount is reset to
zero
- / -
Bin Operating mode selection (MFS job mode, normal
mode)
Bin Operating mode selection (MFS job mode, normal
mode)
Bin Operating mode selection (MFS job mode, normal
mode)
BEI.0194.0 • 2019-08-06