At The End Of A Cleaning Session - Nilfisk T22 Manual De Instrucciones

T22 - T40 - T40W
■
If the pointer is in the red zone (1) it means that the speed
of the air in the vacuum hose is less than 20 m/s, and that
the machine is not operating in optimal conditions. Shake
or replace the filter.
■
during normal operation conditions, close the vacuum
hose, the pointer of the vacuum gauge must switch from
the green zone (3) to the red zone (1).
When the machine is operating, always check that the
vacuum gauge pointer remains in the green zone (3).
Consult the "Troubleshooting" chapter if faults occur.
The air speed in the vacuum hose must not be less than
20 m/s.
Condition indicated by the vacuum gauge pointer in the
green zone (3).
All machines can be used only with hoses whose
diameters comply with the specifications in the
"Technical Data" table.
Consult the "Troubleshooting" chapter if faults occur.
A t t h e e n d o f a c l e a n i n g s e s s i o n
■ Turn off the machine and remove the plug from the socket.
■ Wind up the connection cable.
■
Empty the container and clean the machine as described
in the "Maintenance, cleaning and decontamination"
paragraph.
■ Wash the container with clean water if aggressive
substances have been vacuumed.
■
Store the machine in a dry place, out of reach of
unauthorised people.
■ Lock the castor brakes.
■
During transport and when not using the machine, close
the vacuum inlet with the relevant plug (if equipped).
GB
C 3 5 4
C A U TIO N !
C A U TIO N !
C A U TIO N !
C A U TIO N !
1 0