Key Of Symbols; Qualified Staff; Improper Use - Madas XVO/NC Serie Manual Del Usuario

Electroválvula automática normalmente cerrada para gas con apertura rápida
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1.0 - GENERAL
This manual shows you how to safely install, operate and use the device.
The instructions for use ALWAYS need to be available in the facility where the device is installed.
ATTENTION: installation/wiring/maintenance need to be carried out by qualified staff (as explained
in section 1.3) using appropriate personal protective equipment (PPE).
For any information pertaining to installation/wiring/maintenance or in any case problems that cannot be resolved with the use
of the instructions, it is possible to contact the manufacturer from the address and phone numbers provided on the last page.
1.1 - DESCRIPTION
Normally closed automatic solenoid valves for gas, which open when the coil is electrically powered and close when the power
is cut off.
They can be controlled from pressure switches, thermostats, etc.
Reference standards: EN 161 - EN 13611 - EN 60079-0-7-14-15-18-31.

1.2 - KEY OF SYMBOLS

DANGER: In the event
of inobservance, may
be caused damages to
tangible goods.

1.3 - QUALIFIED STAFF

These are people who:
• Are familiar with product installation, assembly, start-up and maintenance;
• Know the regulations in force in the region or country pertaining to installation and safety;
• Are trained in first aid.
1.4 - USING NON-ORIGINAL SPARE PARTS
• To perform maintenance or change parts (ex. coil, etc.) ONLY manufacturer-recommended parts can be used. Using
different parts not only voids the product warranty, it could compromise correct device operation.
• The manufacturer is not liable for malfunctions caused by unauthorised tampering or use of non-original parts.

1.5 - IMPROPER USE

• The product must only be used for the purpose it was built for.
• It is not allowed to use different fluids than those expressly stated.
• The technical data set forth on the rating plate must not be exceeded whatsoever. The end user or installer is in charge of
implementing proper systems to protect the device, which prevent exceeding the maximum pressure indicated on the plate.
• The manufacturer is not responsible for any damage caused by improper use of the device.
Madas Technical Manual - 1|1.1X - REV. 1 of 6
DANGER:
In
inobservance, may be caused damages
to tangible goods, to people and/or pets.
9
Jul 2020
th
the
event
of
ATTENTION: Attention
is drawn to the technical
details
intended
for
qualified staff.
XVO.../NC - XVOA.../NC

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Xvoa/nc serie

Tabla de contenido