Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1.0 - GENERAL INFORMATION
This manual shows you how to safely install, operate and use the device.
The instructions for use ALWAYS need to be available in the facility where the device is installed.
ATTENTION: installation/wiring/maintenance need to be carried out by qualified staff (as explained
in section 1.3) by using suitable personal protective equipment (PPE).
For any information pertaining to installation/wiring/maintenance or in any case problems that cannot be solved with the
instructions, contact the manufacturer by using the address and phone numbers provided on the last page.
1.1 - DESCRIPTION
Normally closed, manual reset solenoid valves for gas, suitable to shut off gas both to signal danger sent by gas detectors
(methane, LPG, carbon monoxide and similar) or safety thermostats, and in the event of a power cut.
For additional safety, this solenoid valve can only be reset with the power supply on and only when the gas detector is not
signalling danger.
IMPORTANT NOTE: The valve will not open by simply powering the coil. You must manually press the reset
mechanism (as indicated in 4.0).
Reference standards: EN 161 - EN 13611 - EN 60079-0-7-14-15-18-31.
1.2 - KEY OF SYMBOLS
DANGER: In the event
of inobservance, this may
cause damage to tangible
goods.
1.3 - QUALIFIED STAFF
These are people who:
• Are familiar with product installation, assembly, start-up and maintenance;
• Know the regulations in force in the region or country pertaining to installation and safety;
• Are trained on first aid.
1.4 - USING NON-ORIGINAL SPARE PARTS
• To perform maintenance or change parts (e.g. coil, etc.) ONLY manufacturer-recommended parts can be used. Using
different parts not only voids the product warranty, it could compromise correct device operation.
• The manufacturer is not liable for malfunctions caused by unauthorised tampering or use of non-original parts.
1.5 - IMPROPER USE
• The product must only be used for the purpose it was built for.
• It is not allowed to use fluids other than those expressly stated.
• The technical data set forth on the rating plate must not, under any circumstances, be exceeded. The end user or installer is
in charge of implementing correct systems to protect the device, which prevent the maximum pressure indicated on the rating plate
from being exceeded.
• The manufacturer is not responsible for any damage caused by improper use of the device.
Madas Technical Manual - 2|2.1aJ - REV. 0 of 1
DANGER:
In
inobservance, this may cause damage
to tangible goods, to people and/or pets.
9
Aug 2019
st
the
event
of
M14/RMJ N.C. - M14/RMCJ N.C. - M16/RMOJ N.C.
ATTENTION: Attention
is drawn to the technical
details
intended
for
qualified staff.
Publicidad
Tabla de contenido
