Hisense HMO173SR Guía De Uso Y Cuidado página 20

3.
Remove " Parts A " with Nipper or Scissors.
4.
Rotate blower unit counterclockwise 90°.
Before Rotation
Back of
Microwave
5. Place the blower unit back into the opening.
After Fan Blad
Openings Facing Back
End B
CAUTION:
Do not pull or stretch the blower unit wiring.
Make sure the wires are not pinched.
NOTE:
The blower unit exhaust openings should match
exhaust openings on rear of microwave oven.
20
Step-by-step installation guide
Part"A"
After
Back of
Microwave
End A
6. Replace the blower plate in the same position.
7. Attach the exhaust adaptor to the rear of the
oven by sliding it into the guides at the top
center of the back of the oven.
Adaptor
Guide
Push in securely until it is in the lower Blower
Motor screw.Take care to assure that the
damper hinge is installed so that it is at the
top and that the damper swings freely.
8. Secure the blower motor unit to the microwave
with screw as before.
Adaptor
Blower Motor screw
9. Secure the blower plate to the microwave with
screw. Replace the blower plate in the same
position.
Adaptor
Blower plate screw
Back of
Microwave
Guide
Blower Motor screw
Blower Plate
Back of
Microwave
Blower Plate
Back of
Microwave
Blower Plate
& Adaptor screw