Mount The Microwave Oven - Hisense HMO173SR Guía De Uso Y Cuidado

A4.

MOUNT THE MICROWAVE OVEN

Do not grip or use handle during installation.
IMPORTANT:
If filler blocks are not used, case damage may occur from over tightening screws.
If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the
cord. We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf.
NOTE:
When mounting the microwave oven, thread power cord through hole in bottom of top cabinet. Keep
it tight throughout Step 1-3. Do not pinch cord or lift oven by pulling cord.
nylon grommet
metal cabinet
The Filler Block is only used for recessed cabinet and front overhang cabinet (see the type of
the cabinet on page 10、11), you should place the Filler Block to the cabinet bottom before
installing the oven.
5.Tighten the outer two screws to the top of the microwave oven.(During tightening screws, hold the
microwave oven inplace against the wall and the top cabinet.)
16
Step-by-step installation guide
power cord
power cord
hole
Cabinet Front
Cabinet Botto
Microwave Oven top
FOR EASIER INSTALLATION AND
PERSONAL SAFETY, WE RECOMMEND
THAT TWO PEOPLE INSTALL THIS
MICROWAVE OVEN.
1. Lift microwave ,tilt it forward, and hook slots at back bottom
edge onto four lower tabs of mounting plate.
2.Rotate front of oven up against cabinet bottom.
3.Attach the microwave oven to the top cabinet.
4.Insert 2 self-aligning machine screws(1/4"-20X3") through
outer top cabinet holes.Temporarily secure the oven by turning
the screw at least two full turns after the threads have
engaged. (It will be compeltely tightened later.)Be sure to keep
power cord tight.Be careful not to pinch the cord,especially
when mounting flush to the bottom of cabinet.
Turn two full turns on each screw.
Washer
Filler Block
Equivalent to
Depth of Cabinet
Recess
Self-Aligning machine Screw
self-aligning
machine screw
washer