Determing Top Line Of Rear Wall Template Location - Hisense HMO173SR Guía De Uso Y Cuidado

C. DETERMING TOP LI NE OF REAR WALL TEMPLATE
LOCATION UNDER YOUR CABINET
The bottom of the cabinet have three types:
1.Beneath flat bottom cabinet
TOP LINE OF REAR WALL TEMPLATE
Must align with cabinet bottom
NOTE: IT IS VERY IMPORTANT TO
READ AND FOLLLOW THE DIRECTIONS
IN THE INSTALLIONS INSTRUCTIONS
F.CUT OUT FOR
BEFORE PROCEEDING WITH THIS
REAR WALL TEMPLATE. OUTSIDE EXHAUST
This template is for locating the horizontal exhaust CUT HOLE THROUGH REAR WALL FOR EXHAUST ADAPTOR
cutout .Do not use this temlate for vertical or
recirculation exhaust.
1.Tape the template to the rear wall.
2. Use a saber or keyhole saw to cut out the
shaded area F.through the rear wall.
3. Remove the template from the rear wall.
CAUTION -IF EXHAUST ADAPTOR IS POSITIONED OUTSIDE
4. R eturn to and proceed with the installation
RECOMMENDED DIMENSION, GREASE-LADEN AIR WILL
instructions.
TOP LINE OF REAR WALL TEMPLATE
TOP LINE OF REAR WALL TEMPLATE
Trim the rear wall template along the dotted line.
Step-by-step installation guide
HORIZONTAL
DISCHARGE INTO HOUSE STRUCTURE
NOTE: IT IS VERY IMPORTANT TO
READ AND FOLLLOW THE DIRECTIONS
IN THE INSTALLIONS INSTRUCTIONS
BEFORE PROCEEDING WITH THIS
REAR WALL TEMPLATE.
This template is for locating the horizontal exhaust
cutout .Do not use this temlate for vertical or
recirculation exhaust.
1.Tape the template to the rear wall.
2. Use a saber or keyhole saw to cut out the
shaded area F.through the rear wall.
3. Remove the template from the rear wall.
4. R eturn to and proceed with the installation
instructions.
Locate and mark holes to align with holes in the
mounting plate.
IMPORTANT:
LOCATE AT LEAST ONE STUD ON EITHER SIDE OF
THE CENTER LINE.
MARK THE LOCATION FOR 2 ADDTIONAL,EVENLY
SPACED TOGGLE BOLTS IN THE MOUNTING PLATE
AREA.
A
NOTE: IT IS VERY IMPORTANT TO
READ AND FOLLLOW THE DIRECTIONS
IN THE INSTALLIONS INSTRUCTIONS
BEFORE PROCEEDING WITH THIS
REAR WALL TEMPLATE.
This template is for locating the horizontal exhaust
cutout .Do not use this temlate for vertical or
recirculation exhaust.
1.Tape the template to the rear wall.
2. Use a saber or keyhole saw to cut out the
shaded area F.through the rear wall.
3. Remove the template from the rear wall.
4. Return to and proceed with the installation
Locate and mark holes to align with holes in the
mounting plate.
IMPORTANT:
LOCATE AT LEAST ONE STUD ON EITHER SIDE OF THE CENTER LINE.
MARK THE LOCATION FOR 2 ADDTIONAL,EVENLY SPACED TOGGLE BOLTS IN THE
MOUNTING PLATE AREA.
Trim the rear wall template along the dotted line.
A
F.CUT OUT FOR HORIZONTAL
OUTSIDE EXHAUST
CUT HOLE THROUGH REAR WALL FOR EXHAUST ADAPTOR
CAUTION -IF EXHAUST ADAPTOR IS POSITIONED OUTSIDE
RECOMMENDED DIMENSION, GREASE-LADEN AIR WILL
DISCHARGE INTO HOUSE STRUCTURE
REAR WALL TEMPLATE
C
Front
Rear
F.CUT OUT FOR HORIZONTAL
OUTSIDE EXHAUST
CUT HOLE THROUGH REAR WALL FOR EXHAUST ADAPTOR
CAUTION -IF EXHAUST ADAPTOR I S POSITIONED OUTSIDE
RECOMMENDED DIMENSION, GREA SE-LADEN AIR WILL
DISCHARGE INTO HOUS E STRUCTURE
REAR WALL TEMPLATE
B
C
At least 30"
B
9