Mounting And Removing The Guide Bar And Saw; Mounting The Guide Bar And The Saw Chain - Stihl MSE 141 C Manual De Instrucciones

11 Assembling the Chain Saw
– The pitch (t) of the saw chain (1), chain sprocket and, if
applicable, the nose sprocket of the Rollomatic guide bar
must match.
– The drive link gauge (2) of the saw chain must match the
groove width of the guide bar (3).
11.2 Mounting and Removing the Guide Bar and
Saw Chain

11.2.1 Mounting the Guide Bar and the Saw Chain

WARNING
Make sure the chain saw is disconnected from the power
supply and the chain brake is engaged before starting
assembly. Never operate your chain saw without a properly
mounted guide bar and saw chain, @ 6.6. Use only guide
bar and saw chain combinations expressly recommended or
approved by STIHL, @ 6.4.
WARNING
The saw chain has many sharp cutters. If they contact your
flesh, they will cut you, even if the saw chain is not moving,
@ 6.4. Always wear heavy-duty work gloves when
mounting or otherwise handling the saw chain, @ 6.3.
To mount the guide bar and saw chain:
► Switch off the chain saw, @ 14.2.
► Engage the chain brake, @ 12.1.
► Disconnect the chain saw from the power supply.
0458-729-8621-A
► Unscrew the nut (1).
► Remove the chain sprocket cover (2).
► Turn the side chain tensioner (3) counterclockwise until
the tensioning gear (4) sits flush against the housing.
► Position the saw chain in the groove of the guide bar,
starting at the tip.
► Make sure that the cutters in the groove on the top side of
the guide bar face the tip of the bar. STIHL saw chains are
manufactured with arrows on the tie straps to help the
operator determine the proper direction of the chain.
Arrows on the tie straps on the top of the bar must point
toward the bar tip.
1
English
3
4
31