Assembling The Cast Arm And Guard - Stihl Cutquik TS 410 Manual De Instrucciones

Assembling the cast arm
and guard
The cast arm with guard is mounted on
the inboard side by the manufacturer.
The cast arm with guard can also be
mounted on the outboard side
depending on requirements.
Assembly on the inboard side is
recommended for freehand cutting on
account of the better balance; outboard
mounting is recommended when the
machine is mounted on a STIHL cut-off
machine cart.
Outboard mounting
2
1
: Disassemble the abrasive wheel
(see "Fitting / replacing an abrasive
wheel")
: Unscrew the banjo bolt (1)
: Remove the square nut from the
guide from the inboard side of the
guard
: Detach the water attachment (2)
from the adjusting lever and pull it
out of the V-belt guard
TS 410, TS 420
2
1
: Turn the guard in the direction of the
arrow until the adjusting lever points
forwards
: Undo the banjo bolt (1) and remove
the bolt and washer
: Remove the square nut from the
guide from the inboard side of the
guard
: Remove the bolt (2)
: Turn the adjusting lever upwards
and remove
English / USA
2
3
1
: Move the adjusting lever (1) to
position A
: Screw in the bolt (2) and tighten up
: Insert the square nut into the guide
in the guard and hold it in place
: Screw the shorter banjo bolt (3) and
washer on to the adjusting lever and
tighten up
: Turn the guard in the direction of the
arrow until the adjusting lever points
forwards
A
25