Kit Assembly - Metra 99-8242G Instrucciones De Instalación

1. Secure the (4) panel clip legs to the
radio trim panel using (8) #4 x 3/8"
Phillips screws provided. Attach the (4)
factory panel clips to the legs. (Figure A)
2. Secure the pocket to the radio brackets
using the (4) #8 x 3/8"screws provided.
(Figure B)
3. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
4. Slide the radio between the radio
brackets, then secure using the screws
supplied with the radio. (Figure C)
5. Locate the factory wiring harness and
antenna connector in the dash. Metra
recommends using the proper mating
adapter from Metra or AXXESS. Test the
radio for proper operation.
6. Secure the radio assembly into the dash
using the factory screws.
7. Snap the radio trim panel over the
radio, then reassemble the dash
in reverse order of disassembly to
complete the installation.

KIT ASSEMBLY

(Figure A) (Figure B) (Figure C)
REV. 8/6/2019 INST99-8242G
3