Lactina - Medela symphony Instrucciones

7. Assembly of Pump Kit - Lactina
T Tip
Carry out all the steps with care and
assemble the pump kit correctly for
optimum performance.
Parts Needed:
• Tubing

• Lactina

pump
®
• Breastshields
• Breastmilk bottles/containers
• Lids
• Connectors
• Valves
• Membranes
• Piston
• Cylinder
• Pump Connector
Note
• Use Authentic Medela Spare Parts
only. See page 5 for details.
• Check pump kit components for
wear or damage before use and
replace if necessary.
• All components must be completely
dry before use for proper
performance and to prevent
damage to the pump.
20
®
7B. Lactina
1
Caution
Wash hands thoroughly with soap and
water before touching breastpump, kit
and breasts, avoid touching the inside of
containers or lids.
4
Attach pump connector to
Lactina, and rotate cylinder
down into position.
7
Snap membranes onto yellow
valves until membranes
lie fl at.
2
Cylinder Piston
Slide the vacuum regulator
ring onto cylinder. Push handle
end of piston into cylinder.
5
Slip piston into pumping arm
cradle, and push down until snug.
8
Push yellow valves onto inner
rings of connector bottoms.
Questions? Visit www.medela.com or call us at 1-800-435-8316.
3
Pump connector
Screw cylinder tightly into
Lactina pump connector.
6
Securely attach breastshields to
connectors.
Warning
Refer to breastpump instructions
for use for important safeguards
and operating information.
21