Tubing Care; Symphony - Medela symphony Instrucciones

6. Tubing Care

Supplies needed:
• Mild dish soap
• Clean dish towel
• Clean sink or bowl
• Drinking quality water
Parts needed:
• Tubing

• Symphony

or Lactina pump
® ®
• Membrane cap (Symphony)
• Protective membrane
(Symphony)
• Piston (Lactina)
• Cylinder (Lactina)
• Pump connector (Lactina)
Lactina
1
Turn off breastpump.
5
Rinse tubing in cool water to
remove breastmilk.
14
• Inspect tubing after each pumping
session.
Note
Only wash tubing if condensation
or milk is present.
1
Symphony
Turn off breastpump.
Lactina
2
Unplug breastpump from
power source.
6
• Wash tubing in warm soapy water.
• Rinse tubing with clear water.
• Hang to air dry or shake out any
drops of water from the tubing and let
the pump run with tubing attached for
1-2 minutes until dry.
Caution
• Do not store wet or damp parts as mold may develop.
• If tubing becomes moldy, discontinue use and replace tubing. Contact Medela
Customer Service at customer.service@medela.com or call 1-800-435-8316.
2 Symphony
Unplug breastpump from
power source.
Lactina
3
Remove tubing from port on
pump connector. Follow cleaning
instructions for remaining kit parts
in section 4.
Warning
Breastpump kits are a personal
care item intended for use by a
single user only and should not
be shared between users.
Questions? Visit www.medela.com or call us at 1-800-435-8316.
3 Symphony
Remove tubing, protective
membrane, and membrane cap.
Clean following steps in section 4.
4
Remove tubing from
breastshield.
Warning
Refer to breastpump instructions
for use for important safeguards
and operating information.
15