Maintenance - Thermo Fisher Scientific mySPIN 6 Manual De Instrucciones

Maintenance

mySPIN 6 is normally maintenance-free. Clean unit only when it is not plugged
into an electrical outlet. When necessary, the housing and rotor can be wiped
using a damp cloth and a mild, non‐corrosive detergent.
WARNING
plastic or cause cracks in the rotor or the unit. Avoid exposure to
UV radiation, either natural or man‐made. In addition to cracks;
discoloration, softening, or crazing of the plastic materials can
occur. Corrosion can also occur to the metal parts which are part
of the SnapSpin
Ensure the rotor is protected from corrosion and mechanical
damage. The rotor must be cleaned with a neutral cleaning liquid.
Ensure all parts are dry prior to operation.
Notice
The transport box can be cleaned using soap, water, bleach mixture, IPA &
Ethanol. It is autoclavable at 121°C for 15 minutes.
WARNING
damage the transport box. The box shall be unlocked and open
during autoclaving with the silicone seal left in place.
mySPIN 6 Instruction Manual
Do not use any solvent on the unit that may attack
TM
rotor feature. This damage can weaken them.
Higher temperatures or autoclaving duration may
Maintenance | 11