V2 FORTECO 2500-I Manual Del Usuario página 71

DISPLAY DATA DESCRIPTION
AUS Auxiliary channel
tiM - Timed function (from 0 to 20')
biSt - Bistable operation
Mon - Monostable operation
LP.PA no/Si Flashing unit paused
St.rt Start inputs
StAn - Standard operation
no - Inputs from terminal board disabled
AP.CH - Separate opening and closing commands
PrES - Man-present operation
oroL - Timer operation
StoP STOP input
no - The input is disabled: the STOP command is not received
ProS - The STOP command stops the gate: The next START does not invert the direction
invE - The STOP command stops the gate: The next START inverts the direction
Fot 1 Interior photocell input
no - Disabled
APCh - Functions as an active photocell during opening and closure
Fot 2 Exterior photocell input
CFCh - Functions as an active photocell during closure and with the gate stopped
Ch - Only functions as an active photocell during closure
no - Disabled
Ft.tE no/Si Photocell testing
CoS1 Edge 1 input
no - Input inactive
APCH - Input active during opening and closing
AP - Input only active during opening
CoS2 Edge 2 input
no - Input inactive
APCH - Input active during opening and closing
CH - Input only active during closing
Co.tE Safety edge operational testing
no - Test disabled
rESi - Test enabled f
Foto - Test enabled for optical edges
FC.En Si/no End of stroke inputs
i.ADi no/Si Enabling the ADI device
FinE End programming.
no - Do not exit the programming menu
Si - Exit from the programming menu, storing the parameters set
69
MEMO
DEFAULT
DATA
Mon
no
StAn
no
no
CFCh
no
no
no
no
Si
no
no