Programming Auto-Off Time - Health O Meter 2210KL Manual Del Usuario

OPERATING INSTRUCTIONS (CONT)
Using the Reweigh Function
The Reweigh function is used to reweigh the baby while he or she is still on the tray.
To reweigh, the baby should remain on the tray and a weight measurement should be on the
display. Simply press REWEIGH/ RECALL
Using the Recall Function
The Recall function is used to recall the last weight measurement after the scale has shut down
and the display is blank.
The scale automatically stores the last weight measurement. This value is stored until a new
measurement is taken or it is intentionally cleared.
To recall a weight value:
1. The baby's weight has been measured, the baby has been removed from the tray and the
display is blank (scale has shut down).
2. Press ON/ZERO and then REWEIGH/ RECALL. The stored value will now display.
3. With the weight measurement in the display, the scale will be returned to the unlocked mode
(ready for weighing) by either of the following:
a. RECALL is pressed again
b. ON/ZERO is pressed

Programming Auto-Off Time

The 2210KL has been pre-set at the factory to shut down after one minute of no use. This can
be programmed from 12 seconds to 25 minutes to suit your needs.
1. Press ON/ZERO and wait for the display to show "0.0". Do not place anything on tray.
2. Hold MENU button down and press the RECALL button. "Set-0" will be displayed along with
the up and down arrows; the "0" will be flashing.
3. Press the button repeatedly until "Set-3" appears, press ENTER.
4. The Auto-Off time currently programmed in the scale will display as minutes and tenths of
minutes (i.e. "03.2"); the far left digit will be flashing. Use the
desired value, press ENTER to advance to the next digit. For example, setting the time to "00.5"
will turn the scale off after 30 seconds of no use; "02.0" will turn the scale off after 2 minutes;
"25.0" will turn the scale off after 25 minutes.
5. Press ENTER when complete to save and return to normal weighing operation.
ENTER
MENU
Figure 7: Menu button
11
and buttons to set the