diversey TASKI ergodisc omni Manual De Instrucciones página 42

Beginning work with the machine
Attention:
Always wear slip-resistant shoes and ap-
propriate working clothes when working
with this machine!
Attention:
Start familiarization with the machine by
making your first driving attempts in a free
area.
Cleaning start
• Insert the plug into the mains socket.
The display lights up.
• Hold the power supply cord in your hand.
Ensure that the power supply cord cannot come into con
tact with the tool.
• Hold the machine with both hands.
• Push the safety switch and operate
the operating lever at the same time.
The tool is activated.
Notice:
Lifting the guide rod slightly moves the ma-
chine to the right, lowering the guide rod
slightly moves the machine to the left.
Stairs
Notice:
The machine must only be transported
over stairs by two persons.
• Switch off the machine.
• Remove the plug from the mains socket.
Attention:
Lifting the machine can be dangerous un-
der any circumstances!
Stumbling may cause personal injuries or
machine damage.
• To lift the machine, one person
should hold the shell handle while the
other takes the machine handle.
40
End of operation
• Release the operating lever.
• Remove the plug from the mains socket.
Attention:
The machine must now be emptied and
cleaned. Switch off the machine (main
switch) and remove the plug from the
mains socket.
-
Notice:
Remove the product tank before tilting the
machine backward.
• Stand behind the machine.
• Pull the adjusting lever located on the
machine handle and tilt the guide bar
slowly upwards until it is completely
upright.
• Release the adjusting lever to lock
the guide bar.
• Tilt the machine backward until the
machine handle is resting on the
floor.
• Unscrew the holding piece from the
pad holder.
• Remove the pad.
• Fasten the holding piece back into
place with the screws.
Be sure to make the screws very tight
as a protruding holding piece can
damage floors.
• Slowly raise the machine back to the
upright position.