Error Codes; Transport; Disposal - diversey TASKI swingo XP-R Manual De Instrucciones

Error codes

Error codes are indicated on the display.
Notice:
Switch the machine off and on again
whenever an error code occurs.
Error codes might be remedied by switch-
ing the machine off and on.
Code Description
E 020 Battery in deep discharge
The battery voltage fell below 20.5V.
E 041 The current difference between the brush motors is higher than 50% for 15
sec.
The brush unit is lifted.
E 048 Short circuit detection or overload condition (e.g. blocked wheels or brush-
es)
Traction motor, brush motor or suction motor is switched off.
E 051 Incorrect parameters
The parameter checksum is incorrect.

Transport

Attention:
This machine may only be lifted using lift-
ing gear (e.g. hoist, loading ramp, etc.).
Notice:
Transport the machine in an upright posi-
tion.
Notice:
Make sure that the machine is lashed and
secured in the transport vehicle.

Disposal

Notice:
After withdrawal from service, the machine
and accessory parts must be adequately
disposed of in compliance with the nation-
al regulations. Please contact your Di-
versey service partner for help.
Batteries
Attention:
Remove all batteries from the machine pri-
or to disposal.
Used batteries must be disposed of in an
environmentally friendly way in compli-
ance with the EC directive 2006/66/EC or
the respective national regulations.
106
Remedy
Machine requires complete charging
cycle.
Contact your service partner
Switch off the machine and let it cool
down.
Contact your service partner
Contact your service partner
Contact your service partner