BH FITNESS YH2000 Manual Del Usuario página 6

FITTING THE BATTERIES.-
This monitor
ALKALINE BATTERIES. To fit the
batteries, carefully insert the two "R-6"
type batteries
compartment (A), Fig.1, making sure
that the battery's polarity is correct
(matching the battery's "+" terminal
with the "+" sign inside the battery
compartment, and the "-" terminal with
the "-" sign). Replace the battery
compartment cover.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
Important. Deposit all spent batteries
or waste packaging
containers, Fig.2.
ELECTRONIC MONITOR.-
To give you greater control over the
exercise, this electronic unit gives
simultaneous read-outs of speed and
rpm alternating with distance, exercise
time, calories burnt and pulse rate.
The screen will switch itself on
automatically as soon as you start
exercising or by pressing any key on
the monitor. The monitor switches on
as soon as you start to exercise on the
machine.
By pressing the ENTER key or
UP+DOWN during 2 seconds the
value will be reset and the screen will
display the time and temperature.
uses two 1.5
into the battery
in special
English
The monitor will switch itself off
automatically if the unit stands idle for
volt
more than 4 minutes, with the screen
displaying the time and temperature.
A. TIME FUNCTION
This function counts up or down in
steps of one minute, up to a maximum
of 99:00 minutes.
1. Pressing the ENTER key will select
the TIME window, the value to be
programmed will start flashing.
2. Pressing the UP/DOWN key will
display
time.
3. Begin the exercise and when the
time
elapsed the monitor will emit a beep
for 5 seconds, and the time will begin
to increase automatically.
B. DISTANCE FUNCTION
This function counts up or down in
steps of 1 km, up to a maximum of 99
km.
1. Pressing the ENTER key will select
the DISTANCE window, the value to
be programmed will start flashing.
2. Pressing UP/DOWN will display the
programmed exercise distance.
3. Begin
programmed distance has finished,
the monitor will beep for 5 seconds
and then begin to increase the
distance automatically.
C. CALORIE FUNCTION
This function counts up or down in
steps of 10 calories, up to a maximum
of 990 kcal.
6
the programmed
that you programmed
the exercise.
exercise
has
When the