Unpacking; Table Stand Assembly - Kobalt KT10152 Manual De Instrucciones

ASSEMBLY INSTRUCTIONS

UNPACKING

1. Cut sides of box at all four corners.
IMPORTANT: Before assembly, separate upper
and lower packing trays. Leave base section in
lower tray while completing steps 1 - 8.
DD

TABLE STAND ASSEMBLY

2. First remove washers (KK) and nuts (JJ) from
lower right leg assembly, then attach wheels
CC
(K) to lower right leg assembly (J) with washers
(KK) (one on each side of wheel) and nut (JJ).
Check orientation of wheels and if wheels rub
against frame, reverse orientation. Set wheel
Spacer
assembly aside for later use.
Qty. 6
Hardware Used
JJ
KK
Washer
Nut
2 in. Bolt
JJ
Nut
(preassembled
to lower right
Qty. 2
leg assembly)
3. Attach left leg cross piece (R) to left front leg (M)
and left rear leg (N) with M6 x 50 bolts (CC).
Qty. 2
Hardware Used
CC
M6 x 50mm (1.97")
HH
EE
DD
Nut
Qty. 10
KK
Spacer
Qty. 6
JJ
Washer
(preassembled
to lower right
leg assembly)
Nut
Qty. 4
(preassembled (preassembled
to lower right
leg assembly)
Qty. 2
1
2
EE
Nut
Qty. 10
KK
x 4
KK
x 2
3
Washer
to lower right
leg assembly)
Qty. 4
x 2
15
J
KK
K
JJ
M
CC
R
kobalttools.com
N