Blades - Kobalt KT10152 Manual De Instrucciones

BEFORE OPERATING

BLADES

• Your saw comes equipped with a 10 in. combination blade suitable for ripping and cross-cutting.
Additional blade styles are available for specific operations such as ripping. Your local dealer can
provide you with complete information.
• Kerf width must be within the limits stamped on the riving knife (X).
• Only use 10 in. blades designed for wood cutting.
Changing Blade Depth
Blade depth should be set so that outer points of blade
(W) are higher than workpiece by approximately 1/8 in.
to 1/4 in. and bottom of gullets are below top surface of
workpiece.
1. Make sure release lever (O) is locked (in down
position).
2. Raise blade (W) by turning height adjusting wheel (P)
clockwise. Lower blade (W) by turning height/bev
Changing Blade Angle (Bevel)
Note: A 90° cut has a 0° bevel and a 45° cut has a 45° bevel.
Note: If bevel indicator is not at zero when saw blade is
at 0°, see Adjusting Bevel Indicator, page 46.
1. Loosen bevel control by pulling release lever (O) all
the way to the right.
2. Adjust bevel angle by first pushing height adjusting
wheel assembly all the way to the left, maximum 45°.
3. Holding knob/wheel, slide bevel indicator to the right
to increase angle of blade (W) (bringing it closer to
45° from the tabletop). Holding knob/wheel, slide
bevel indicator to the left to decreases the angle
(bringing blade closer to 90° from the tabletop).
4. Make sure blade (W) is at desired angle. To lock
tighten bevel control by pushing release lever (O) to
the left.
27
kobalttools.com