Assembly Instructions - Kobalt KT10152 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY INSTRUCTIONS

• DO NOT use this product if any parts on the Loose Parts List are already assembled to your product
when you unpack it. Parts on this list are not assembled to the product by the manufacturer and
require customer installation. Use of a product that may have been improperly assembled could
result in serious personal injury.
• If any parts are damaged or missing, DO NOT operate this saw until the parts are replaced. Use of
this product with damaged or missing parts could result in serious personal injury.
• DO NOT attempt to modify this saw or create accessories not recommended for use with this saw.
Any such alteration or modification is misuse and could result in a hazardous condition leading to
possible serious personal injury.
• DO NOT connect to power supply until assembly is complete. Failure to comply could
result in accidental starting and possible serious personal injury.
• DO NOT lift the saw without help. Hold it close to your body. Keep your knees bent and lift with your
legs, not your back. Ignoring these precautions can result in back injury.
• NEVER stand directly in line with the blade or allow hands to come closer than 6 in. to the blade.
DO NOT reach over or across the blade. Failure to heed this warning can result in serious personal
injury.
• FULLY ASSEMBLE saw with leg assembly prior to use. Leg assembly is an integral and necessary
part of the support structure for this saw.
This product requires assembly.
• Carefully remove the upper piece of packaging material and leave the saw in the lower piece of
packaging material.
• This tool is heavy. To avoid back injury, keep your knees bent and lift with your legs, not your back.
Get help when needed.
• Inspect the tool carefully to make sure no breakage or damage occurred during shipping.
• DO NOT discard the packaging material until you have carefully inspected the tool, identified all
loose parts, and satisfactorily operated the tool.
• The saw is factory set for accurate cutting. After assembling it, check for accuracy. If shipping has
influenced the settings, refer to specific procedures explained in this manual.
• If any parts are damaged or missing, please call 1-888-356-2258 for assistance.
WARNING
14
kobalttools.com

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

1303497

Tabla de contenido