Healing (Paralleling) Blade To Miter Gauge Groove - Kobalt KT10152 Manual De Instrucciones

ADJUSTMENTS
HEELING (PARALLELING) BLADE TO MITER GAUGE GROOVE
• Blade (W) must be parallel to miter gauge groove so that wood does not bind, resulting in
kickback. Failure to do so could result in serious personal injury.
• To reduce risk of injury from kickback, align rip fence (T) to blade (W) following any blade
adjustments.
DO NOT loosen any screws for this adjustment until alignment has been checked with a square to be
sure adjustments are necessary. Once screws are loosened, items must be reset.
Note: Unplug saw. Remove blade guard (A) and anti-kickback pawls (B). Raise the blade (W) by
turning height adjusting wheel (P).
1. Mark beside one of blade teeth at front of blade (W).
Place a combination square even with front of saw
table (V) and side of saw blade (W) as shown.
2. Turn blade (W) so that marked tooth is at back. Move
combination square to the rear and again measure
the distance. If the distances are the same, blade (W)
is square.
WARNING
44
kobalttools.com