Fastening The V-Block En; Mounting The Milling Cutter En - Abicor Binzel BRS-CCi Instructivo De Servicio

BRS-CCi
Cleaning unit
1
Clamping device
2
Putting into operation
Fig. 4
6.1 Installation
 See Fig. 4 Putting into operation on page EN-9
1 Fasten the support (6) on a vibration-free working surface in the work area of the robot by means of four
screws (5).
6.2 Fastening the V-block
 See Fig. 4 Putting into operation on page EN-9
1 Insert the V-block (3) into the clamping device (2) from above.
2 Screw in the cylinder screw (4).
6.3 Mounting the milling cutter
1 Clamping device
Mounting the milling cutter
Fig. 5
NOTE
• Use only tools with a suitable width across flats when changing the milling cutter. Milling cutter seat
1 Insert the milling cutter (1) into the clamping device (1).
2 Secure the milling cutter (1) by means of tools (2).
1
6
5
V-block
3
V-block screw M5x20
4
1
2 Milling cutter
AF 27, milling cutter AF 17.
2 3
4
4 screws
5
Support stand
6
2
3
3 Tool
6 Putting into operation
EN - 9