Connecting The Pneumatic System En; Putting Out Of Operation; Maintenance And Cleaning - Abicor Binzel BRS-CCi Instructivo De Servicio

BRS-CCi
6.10 Connecting the pneumatic system
For the supply line, a compressed air hose with an inner width of min.
into the angle screw connection at the housing of the cleaning station. A shut-off valve in the supply line is
recommended. This allows the BRS-CCi to be quickly and simply depressurized in order to carry out any
installation and maintenance work.
Fig. 12
7 Operation
NOTE
• As the cleaning station BRS-CCi is integrated into a welding system, the operating instructions of the
• Make sure that the cleaning station BRS-CCi is operated with a front sheet only.
1 Switch on the robot control.
2 Start the welding process.
3 Stop the welding process.

8 Putting out of operation

NOTE
• As the cleaning station BRS-CCi is integrated into a welding system, putting out of operation depends
1 Switch off the robot control.

9 Maintenance and cleaning

Regular and lasting maintenance and cleaning are the prerequisite of a long life and a trouble-free function.
In doing so, observe the following:
Compressed air of motor
Clamping cylinder Lifting cylinder
unscrew clamp
M
Z2
D8/d6
D6/d4
4 2
Y2
14 14 12
12
5 3
1
Connecting the pneumatic system
welding components, such as welding torch and robot control, must be observed during operation.
on the robot control. Please make sure that the shutdown procedures for all components mounted in
the welding system are strictly observed.
ø
Shear
bottom top open closed
Z1 S1 Z3
S4
D6/d4
D8/d6 D6/d4
Y3
4 2 Y1 4
14 14 12 14 14 12
12
5 3 5
1
1
7 Operation
6mm is necessary which is inserted
Injector
M
E
V
P
D6/d4
D6/d4
6x1
2
Y4
12 12
3
Drawing from th
bottle
6 bar
EN - 15