Abicor Binzel BRS-CCi Instructivo De Servicio página 35

BRS-CCi
Fault Cause
Torch parts are damaged • Wrong equipment parts
No spray function • Check level
• Compressed-air supply / hose connections
interrupted
• Directional valve Y4 does not switch
• Valve actuator is stuck
Too much / too little • Metering quantity wrongly adjusted
spray mist
No spray mist • Cylinder empty
Troubleshooting
Tab. 13
11 Dismounting
Dismounting may only be carried out by qualified personnel. Please make sure that the shutdown
procedures are strictly observed, before the dismounting work begins. Ensure this also for the components
integrated into the welding system.
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair work, the following instructions
must be adhered to:
• Switch off the power supply and cut off the compressed air supply.
• Cut off the gas supply.
• Pull the mains plug.
NOTE
• Observe the information given in section 8 Putting out of operation on page EN-15.
1 Unscrew the screws and remove the cleaning unit and the collecting tray.
2 Unscrew the screws and remove the support from the bottom.
12 Disposal
For disposal, the local regulations, laws, provisions, standards and guidelines must be observed. For the
cleaning station BRS-CCi to be properly disposed of, it first must be dismounted.
 See 11 Dismounting on page EN-17
12.1 Materials
This product consists for the most part of plastics, steel and non-ferrous metals. Steel and non-ferrous metals
can be molten in steel and iron works and are thus almost infinitely recyclable. The plastic materials used
are marked in preparation for sorting and separation of the materials for later recycling.
12.2 Consumables
Oils, greases and cleaning agents must not contaminate the ground and not enter sewage systems. These
materials must be stored, transported and disposed of in suitable containers. Please observe the relevant
local regulations and disposal instructions of the safety data sheets given by the manufacturer of the
consumables. Contaminated cleaning tools (brushes, rags, etc.) must also be disposed of in accordance with
the information provided by the manufacturer of the consumables.
DANGER
Solution
• Check torch dependent parts
• Check immersion depth of torch
• Refill anti-spatter fluid
• Check all supply lines leading to the cylinder
and the screwings
• Check signal output of robot control
• Replace directional valve Y4
• Change setting of throttle screw
• Replace cylinder
11 Dismounting
EN - 17