Setting Up The Clamping Position En; Setting Up The Compressed-Air Motor En - Abicor Binzel BRS-CCi Instructivo De Servicio

6 Putting into operation
6.4 Setting up the clamping position
Gas nozzle
1
Setting up the clamping position
Fig. 6
1 Move the torch with the gas nozzle (1) vertically to the tool axis (milling cutter axis) over the cleaning
station BRS-CCi (2) (P1).
2 Approach the clamping position (P2). Make sure that the cylindrical part of the gas nozzle (1) lies evenly
against the V-block (1).
6.5 Setting up the compressed-air motor
1 Clamping device
Gas nozzle
2
Setting up the compressed-air motor
Fig. 7
1 Loosen the compressed-air motor from the guide block (3) by removing the screws (2).
2 Pull back the compressed-air motor (4) in its mount.
3 Place the required distance sleeve (5) on the milling cutter (6).
4 Move the torch with the gas nozzle (2) to the clamping position (P2).
5 Keep the guide block (3) in the lower position (lift down).
6 Place the compressed-air motor (4) against the gas nozzle (2) with the distance sleeve placed on top
(5).
7 Fasten the adjusted motor position by means of the screws (2).
EN - 10
1
V-block
2
1
7
6
5
3 Screws
Guide block
4
2
3
Cleaning station BRS-CCi
3
2
3
4
5 Compressed-air motor
Milling cutter
6
BRS-CCi
7 Distance sleeve