01
Before you start
•
24-bit/192 kHz compatible DAC
The on-board 24-bit/192 kHz DAC means that
this player is fully compatible with high
sampling-rate discs, capable of delivering
exceptional sound quality in terms of dynamic
range, low-level resolution and high-frequency
detail.
•
Built-in Dolby
decoding with multichannel outputs
This player features multichannel analog
outputs for connection to an AV amplifier to
give you stunning surround sound from Dolby
Digital, DTS and multichannel DVD-Audio
discs.
DV-400V only:
•
24-bit/96 kHz compatible DAC
The integrated 24-bit/96 kHz DAC means that
this player is compatible with high sampling-
rate discs, capable of delivering exceptional
sound quality in terms of dynamic range, low-
level resolution and high-frequency detail.
•
Excellent audio performance surround
sound entertainment with Dolby Digital
3
and DTS
software
When connected to a suitable AV amplifier or
receiver, this player gives great surround
sound with Dolby Digital and DTS discs.
1. Manufactured under license from Dolby Laboratories. "Dolby", "Pro Logic", and the double-D symbol are trademarks
of Dolby Laboratories.
2. "DTS" and "DTS Digital Surround" are registered trademarks of DTS, Inc.
6
3. "DTS" is a registered trademark of DTS, Inc. and "DTS 2.0 + Digital Out" is a trademark of DTS, Inc.
En
1
2
Digital and DTS
What's in the box
Please confirm that the following accessories
are in the box when you open it.
• Remote control
• AA/R6P dry cell batteries x 2
• Audio/video cable (red/white/yellow plugs)
• Power cable
• Operating instructions
• Warranty card
Putting the batteries in the remote
•
Open the battery compartment cover
and insert the batteries as shown.
Use two AA/R6P batteries and follow the
indications ( ,
Close the cover when you're finished.
Important
Incorrect use of batteries can result in hazards
1
such as leakage and bursting. Please observe
the following:
• Don't mix new and old batteries together.
• Don't use different kinds of battery
together—although they may look similar,
different batteries may have different
voltages.
• Make sure that the plus and minus ends of
each battery match the indications in the
battery compartment.
• Remove batteries from equipment that
isn't going to be used for a month or more.
) inside the compartment.