Hdmi Troubleshooting - Pioneer DV-600AV-S Manual De Instrucciones

Additional information

HDMI troubleshooting

Problem
No HDMI audio output.
No HDMI video output.
No multichannel HDMI
audio.
No sound is output from
the AUDIO OUT (5.1 ch)
jack when connected via
HDMI.
Component Out cannot
be set to Interlace.
Remedy
• Check whether or not HDMI Out is set to Off. (See HDMI Out on
page 39.)
• This unit has been designed to be compliant with HDMI (High
Definition Multimedia Interface). Depending on the component you
have connected, unreliable signal transfers may result.
• If the front panel HDMI indicator is lit:
– You won't hear any sound from the HDMI output if the source
component is only DVI/HDCP-compatible.
• If the front panel HDMI indicator is unlit then:
– Make sure that you've selected this player as the HDMI input in the
settings for the component you're using. You may need to refer to the
instruction manual of the component to do this.
– Check that the HDMI cable is connected properly and that the cable
isn't damaged.
– Check that components connected using the HDMI interface are
switched on and HDMI compatible.
• Make sure that you've selected this player as the HDMI input in the
settings for the component you're using. You may need to refer to the
instruction manual of the component to do this.
• Check that the HDMI cable is connected properly and that the cable
isn't damaged.
• Check that components connected using the HDMI interface are
switched on and HDMI compatible.
• This unit has been designed to be compliant with HDMI (High
Definition Multimedia Interface). Depending on the component you
have connected, using a DVI connection may result in unreliable
signal transfers.
• Make sure the resolution on this player matches that of the
component you have connected using HDMI. See HDMI Resolution on
page 40 to change the HDMI resolution. See Resetting the output
resolution to the default setting with HDMI connection on page 16 if you
want to reset the output resolution.
• Make sure the HDMI Out setting is set to Auto, Auto (DSD) or
LPCM (5.1CH) (see HDMI Out on page 39 to do this). See also About
the HDMI audio output settings on page 47 and HDMI output with
DVD-Audio and SACD sources on page 48.
• Check whether or not HDMI Out is set to Off. (See HDMI Out on
page 39.)
• You can use the Interlace setting if the HDMI Resolution is set to
720 x 480i (NTSC)/720 x 576i (PAL).
09
57
En