Pioneer AVIC-900DVD Manual Del Instalacion página 11

This product
Power cord
Purple/white (REVERSEGEAR SIGNAL INPUT)
This is connected so that the navigation system can
detect whether the vehicle is moving forwards or
backwards. Connect the purple/white lead to the
lead whose voltage changes when the reverse gear
is engaged. Unless connected, the sensor may not
detect your vehicle travelling forward/backward
properly, and thus the position of your vehicle
detected by the sensor may be misaligned from the
actual position.
Note: When you use the ND-PG1 speed pulse
generator (sold separately), please make sure
to connect it.
Black, Orange/white, Red, Yellow
See Page 11.
Yellow/black
When combining this navigation unit with a Pioneer car stereo,
if the car stereo has yellow/black leads, connect them to those
leads. In this way, when the guidance audio is output and
when you operate the system by voice, the vehicle stereo is
automatically muted to reduce the vehicle stereo volume.
Check the position of your vehicle's
reversing lamp (the one that lights up
when the gearstick is in reverse [R]) and
find the reversing lamp lead in the boot.
Note:
Cords for this product and those for other
products may be different colours even if
they have the same function. When con-
necting this product to another product,
refer to the supplied Installation manuals of
both products and connect cords that have
the same function.
Connection method
Clamp the reversing lamp
lead.
Clamp firmly with
needle-nosed pliers.
Fuse resistor
Reversing lamp lead.
10