Before Installing The Unit; To Prevent Damage; Connecting The System - Pioneer AVIC-900DVD Manual Del Instalacion

Ocultar thumbs Ver también para AVIC-900DVD:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30

Connecting the System

Before installing the unit

• This unit is for vehicles with a 12-volt battery and negative grounding. Before installing
it in a recreational vehicle, lorry, or bus, check the battery voltage.
• To avoid shorts in the electrical sys-
tem, be sure to disconnect the (-) bat-
tery cable before beginning installa-
tion.

To prevent damage

• When disconnecting a connector, pull
the connector itself. Do not pull the
lead, as you may pull it out of the con-
nector.
• If this unit is installed in a vehicle that
does not have an ACC (accessory)
position on the ignition switch, the red
lead of the unit should be connected to
a terminal coupled with ignition switch
ON/OFF operations. If this is not done,
the vehicle battery may be drained
when you are away from the vehicle
for several hours.
• To avoid short-circuiting, cover the
disconnected lead with insulating tape.
5
ACC position
No ACC position

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Avic-800dvdAvic-9dvdiiAvic-8dvdii

Tabla de contenido