Transport And Unpacking The Machine; Transport; Unpacking - Nordcap Moretti Forni iR 260 - iLab Manual Instrucciones

5 - TRANSPORT AND UNPACKING THE MACHINE

5.1 TRANSPORT

The machine must be transported in its original packaging. It must be moved with an adequate
lifting system to avoid damaging it and injuring yourself.
. Do not position anything on the package.
. The machine must always be transported in a vertical position.

5.2 UNPACKING

The machine can be sent packaged with a pallet and cardboard,
cage or crate. The packaged machine can therefore by lifted with a
forklift or pallet truck by inserting the forks in the specific spaces
prepared under the packaging. It can also be lifted with a crane,
passing the ropes or straps under the packaging. In this case,
comply with the maximum tensioning angle of the ropes which must
be 45°, as shown in the figure.
Remove the packaging vertically.
Carefully unpack the machine and check there are no signs of damage from transport. If
found, promptly inform the carrier. You are always advised to photograph the damage.
Remove the fastening brackets as in the figure and, using a forklift (or a lifting device), remove
the machine from the pallet.
To ensure further staff safety, you are advised to maintain a sufficient distance from the
machine when it is being lifted.
UK/7