Integra MAYFIELD Manual Del Instrucciones página 9

7. Thoroughly dry equipment with soft clean towels and use
medically compressed air if needed, to dry channels, crevices and
lumens.
8. Inspect the equipment to make sure there is no visible organic
debris or residue from cleaning agent.
Repeat process if any soil is detected.
Drying
• Products should be dry at this point. If wetness or excess liquid is
detected, dry with a soft clean towel.
• Medically compressed air can be used if needed.
Optional Automatic Wash / Disinfect
CAUTIONS
• Alkaline and highly acidic detergents and solutions cause damage
to the devices.
• Channels and crevices found on these devices require particular
attention during cleaning.
• Pay special attention to the water quality used throughout
reprocessing. Hard water can damage the surface of the
equipment. Avoid using hard water. Instead use purified water
unless otherwise specified.
Limitations on Reprocessing
• Repeated processing has negative effects on these devices and is
not recommended for routine use.
• It is important to have Integra NeuroSpecialists perform routine
inspections. See contact information.
INSTRUCTIONS
Cleaning - Automated Equipment: Neutral pH Detergent
Method
1. Prepare equipment for cleaning by disassembling removable parts
and loosening connections.
2. Rinse equipment in warm water before placing into washer.
3. Load device into the washer and place small parts in container
or tray inside the washer unit in order to avoid loosing small
components.
4. Follow the instructions listed below and set washer machine to
these exact parameters:
Phase
Pre-wash 1
Enzyme
Wash
Wash 1
Time Water
(Min.) Temperature
4:00 Cold water
4:00 Hot water
60.0ºC
10:00
(140º F)
Detergent and
Concentration
N/A
Neutral pH
enzymatic (e.g.
Endozime® AW
Triple Plus with
APA, Ratio 1:128)
Neutral pH
detergent
(e.g. Renu-Klenz™ ,
Steris, Ratio 1:256)
9
English–EN