BMW E39 Manual Del Usuario página 4

1. Important Information
Intended for use in BMW dealership network only.
Specialist knowledge as well as knowledge of the vehicle electrical system required.
These installation instructions apply only to left-hand drive (LHD) vehicles.
Installation time required 2.0 hours.
The installation time may vary depending on the condition and equipment of the vehicle.
•This installation kit may only be installed in connection with a headlight washer system.
•Option SA 500 headlight washer system must be retrofitted first if the vehicle was not equipped with this
optional extra in series production or if SA 500 headlight washer system has not been retrofitted, as the
installation kit xenon headlight with automatic headlight range adjustment must only be installed in
conjunction with SA 500 headlight washer system.
•If installed, the latent heat accumulator must also be removed from the vehicle.The latent heat accumulator
must be removed and installed in accordance with the instructions provided in the currently applicable
Repair Instructions.
•Make sure that the warning sticker provided in the installation kit is affixed to the cross member above the
headlight.
•This xenon headlight installation kit does not require encoding. Instructions for checking the level sensor
and the cold light scan module are provided in Section 2.4 and in the information leaflet (Section 4).
•If changes are made to the running gear or repairs conducted on the rear axle, the adjustment procedure for
the level sensor must be carried out as described in Section 2.4 and in the information leaflet (Section 4).
•Place the information leaflet (Section 4) and the white 2-pin socket housing (wire jumper, red wire)
unplugged during the adjustment procedure in the car's glovebox so that readjustment can be carried out
if necessary.
Safety notes
Particular care must be taken when installing cables/lines to ensure they are not kinked, bent or damaged.
Additionally installed cables/lines must be secured with cable straps.
On no account use "Scotchlock quick-action connectors" as they can cause interference and disturbances in the
vehicle electrical system.
If specified pins or slots are already used, corresponding jumpers, double crimp or parallel connections are to be
used.To avoid problems, make sure you follow the specified cable routes in the vehicle precisely.
Subject to technical modifications
1-2/EN