Faults And Solutions - Nogueira FTN-1000 G3 Manua De Instrucciones

8.- FAULTS AND SOLUTIONS

The following are the most common symptoms of operation failures, their
probable causes and the precautions that should be taken by the user. If you
have any questions, consult your dealer or contact our technical assistance.
The machine is getting clogged.
Probable cause
Excessive volume of gathered crop.
Excessive traveling speed.
Incorrect quantity of rotor knives.
Incorrect mounting of rotor knives. Adjust the correct distribution of knives.
Dull rotor knives.
Dull rotor counter knife.
Weak releasing of chopped crop by the chute.
Probable cause
Tractor below the minimum
recommended power.
Incorrect quantity of rotor knives.
Incorrect mounting of rotor
knives.
Incorrect mounting of rotor knives. Adjust the correct distribution of knives.
Excessive cardan vibration.
Probable cause
Unbalanced cardan.
Turn off the tractor and turn the cardan
shaft on the machine rear in reverse,
expelling excess of crop.
Reduce speed.
Install the correct quantity of rotor
knives.
Sharpen the knives.
Turn over the counter knife or replace it.
Use a tractor with the recommended
power..
Install the correct quantity of rotor
knives.
Install the correct quantity of rotor
knives.
Check if the length adjustment was
performed properly.
Instructions Manual
8. Practical Guide
Solution
Solution
Solution
101