Cutting And Cardan Shaft Coupling - Nogueira SILONOG-F Manual De Instrucciones

Instructions Manual
CUT AND COUPLING OF THE CARDAN
SHAFT
Initially, it is necessary to verify is the cardan length
is adequate to the tractor that will be used. Due to
the variation in the distance between the tractor
PTO and the machine drive shaft, it might be
necessary to cut the cardan. In order to perform
this operation and verification, proceed as follows:
PROCEDURE:
With the machine coupled, manoeuver the tractor
in a way that one of its rear tires gets really close
to the machine hitch, without touching it (see the
picture beside).
Disengage both parts and remove the cardan
plastic protections.
21