1. Faucet Installation
Prepare the Site
NOTE: Before drilling the mounting hole, use the following
provisions for proper placement: (1) A 1-1/4" (32 mm) minimum to
1-1/2" (38 mm) maximum diameter mounting hole is required. (2) A
minimum distance of 1-3/4" (44 mm) is required between the back
of the spout and the wall to allow access to the screw.
NOTE: When K-13460, K-13461, K-13466 or K-13467 are installed to
drop-in sinks (sinks with the rim above the deck), the maximum
height of the edge of the basin lip is 3/4" (19 mm) and the
maximum distance from the edge of the sink to the front edge of the
faucet is 1/2" (13 mm).
NOTE: When K-13472 or K-13473 are installed to drop-in sinks, the
maximum height of the edge of the basin lip is 1-1/4" (32 mm).
Determine the mounting hole location.
Drill a hole through the mounting surface according to the
surface manufacturer's instructions.
Install the Faucet
Install the stud to the underside of the faucet.
Slide the gasket over the flexible hoses and stud, then seat the
gasket in the groove on the underside of the spout.
Insert the spout with flexible hoses and stud through the
mounting hole.
Kohler Co.
Without Escutcheon
Supply Hoses
Gasket
Bracket
3
Spout
Stud
Rubber Washer
Nut
1102759-2-D