Seat; Folding; Maintenance - Be Cool bi-baby Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

EN
holes and through holes in plastic board.
H.4
When refitting shoulder strap choose the fabric
holes appropriate to the child's size. Twist the
buckle and feed through seat fabric holes and
through holes in plastic board.
I. SEAT
BACKREST ADIUSTMENT
I.1
To lower the backrest pull the backrest adjust-
ment handle down until it is adjusted to the required
position.
I.2
To lift the backrest,hold the belts of the adjusting
mechanism (1) and simultaneously move the adjus-
ting mechanism to the required position(2).
I.3
This seat should be used in the most reclined
position until a child can sit up unaided, roll over, or
push itself up on its hands and knees.
30
J. FOLDING
Remove the child from the seat. Press the release
J.1
button on the right hand side at the rear leg till it
clicks to release the main lock.
J.2
Pull upwards on the pull straps underneath the
pocket at the center of both seats with a gentle tug
and your stroller will fold in half.
The stroller stands after fold.
J.3

MAINTENANCE

For the textile parts intended by the manufacturer to
be removable and washable, please read the attached
care label. Never use sharp or abrasive cleaning
products, instead use a mild soap solution or a special
textile cleaning product. The plastic parts and the
frame can also be cleaned with a soap solution. After
using the pram in rain or wet conditions, always clean

Publicidad

Tabla de contenido
loading

Tabla de contenido