Removing And Refiting Safety Harness - Be Cool bi-baby Manual Del Usuario

into the harness buckle until they lock into position.
G.3 Press center release button to release harness.
G.4 To adjust shoulder harness length: Hold the
plastic guide and pull the lower shoulder strap end to
tighten or pull the upper shoulder strap end to loosen.
To adjust waist strap length: Hold the plastic guide
and pull the front waist strap end to tighten or pull
the rear waist strap end to loosen.
To adjust crotch strap length: Hold the plastic guide
and pull the lower crotch strap end to tighten or pull
the upper crotch strap end to loosen.
To adjust harness height: Holding the shoulder
G.5
strap and plastic guide, slide the guide down to
shorten the harness height or slide the plastic guide
up to increase the harness height.
WARNING: Harness straps have loops that can cause
strangulation.
_WHEN NOT IN USE, DISCONNECT SHOULDER
STRAPS FROM THE WAIST STRAP AND/OR BUCKLE.
WARNING: USE THIS HARNESS AT ALL TIMES.
WARNING: Avoid serious injury from falling or
sliding out. Always properly adjust and fasten safety
harness.Gently pull on the Rear Wheel to make sure
it is properly attached.
H. REMOVING AND REFITING SAFETY
HARNESS
H.1 Twist shoulder strap end buckles and feed
through seat fabric holes and through holes in plastic
board.
H.2 Twist waist harness strap end buckles and feed
through seat fabric holes and through holes in
plastic board.
Feed crotch strap buckle through seat fabric
H.3
EN
29