Description Of Unit; Application; Requirements; Hardware - Bosch KTS 530 Descripción Del Producto

en 2� | ��S ��� � ��S ��� � ��S ��� | Description of unit
3.

Description of unit

�.1

Application

KTS 530, KTS 540 and KTS 570 (hereinafter referred to as
KTS modules) are modules for controller diagnosis. The
functionality differences are shown in the following table:
Function
Controller diagnosis
1 channel multimeter
2 channel multimeter
2 channel oscilloscope
2 channel diagnosis oscilloscope –
Bluetooth wireless connection
USB connection
KTS modules can perform the following functions with
ESI[tronic]:
R
Controller diagnosis , with e.g.
$
Read error memory
$
Display actual values
$
Initiate actuators
$
Use of other controller-specific functions
R
Multimeter measurements
$
Voltage measurement
$
Resistance measurement
$
Current measurement (only with special accessory
current measuring clips or shunt)
R
2 channel oscilloscope
ment values (��S ��� only).
R
2 channel diagnosis oscilloscope
ler diagnosis interface (��S ��� only).
|
1 689 979 987 2008-07-02
��S ��� ��S ��� ��S ���
X X X
X X X
– – X
– – X
– X
– X X
X X X
for
for determining measure-
for testing the control-
�.2

Requirements

�.2.1

Hardware

PC/Laptop with at least one free USB interface.
KTS modules can be used with the following Bosch
products:
R
Emissions System Analysis
R
FSA 740
R
BEA 810, BEA 840, BEA 850
Depending on the software version.
*)
�.2.2

Operating system

Operating system
WIN XP/Vista
�.2.�

Software

In order to operate the KTS module, the current
ESI[tronic] software must be installed and enabled on
the PC/laptop. Extra costs apply in this case.
*)
*)
USB Bluetooth
X X
Robert Bosch GmbH