Initial Start-Up; Esi[Tronic] Software Installation; Connection; 18 4.3 Configuration (Ddc) - Bosch KTS 530 Descripción Del Producto

en 26 | ��S ��� � ��S ��� � ��S ��� | Initial start-up
4.

Initial start-up

!
It is not possible to operate another piece of bluetooth
hardware installed or plugged into the PC/laptop, as
the data communication between the KTS module and
the control unit would be disrupted as a result.
Before the initial startup of the bluetooth USB ad-
1.
apter, the bluetooth hardware integrated in the PC/
laptop (e.g. Widcomm Stack/Toshiba Stack) must be
deactivated (see PC/laptop operating instructions).
2. In addition, the appropriate bluetooth driver must be
uninstalled (remove bluetooth driver under "Start >>
Settings >> Control Panel >> Software").
!
Do not plug in the Bluetooth USB adapter until
requested to do so during installation of the Blue-
tooth driver on your PC or laptop
(Message: Connect Bluetooth device).
If the Bluetooth USB adapter is plugged in too soon, the
Windows hardware assistant is opened. The Windows
hardware assistant must be terminated and the
Bluetooth USB adapter removed.
�.1

ESI[tronic] software installation

1. Install current ESI[tronic] DVD.
i
Depending on the type of installation selected,
you will be asked to insert ESI[tronic] 2006/1
during the installation.
2. If the ESI[tronic] has not been enabled yet, enable it
now.
i
How to install and enable the ESI[tronic] is described
on the "ESI[tronic] DVD 1 Diagnosis and technology"
in the directory 'Docs\Setup\INFO_XXX.PDF'.
�.2

Connection

1. Connect the KTS module with the power supply
included with the delivery.
2. Connect the KTS module with the PC/Laptop using
the USB connection cable.
i
The message "Found new hardware" will appear
on the screen the first time that the KTS modules
are connected using the USB connection cable.
This indicates that the USB connection to the
KTS modules has been recognized.
|
1 689 979 987 2008-07-02
�.� Configuration (DDC)
i
The function of the DDC (Diagnostic Device Configu-
ration) software is to configure, activate and test the
KTS modules.
1. Start the DDC (" Start >> Settings >> Control panel").
2. Add the KTS module via "
i
Other procedures for configuration concerning the
initial start-up are described in the online help. Use
<Help> to open the online help. All other important
information concerning DDC is found here as well.
i
If you have any questions which cannot be answered
by the online Help, please contact the ESI[tronic]
service hotline directly.
New".
Robert Bosch GmbH